FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

5/13/2017 9:01 PM  #1


Fitting rear bumper on a 65 coupe

I've got a brand new rear bumper and brackets, fits good along the rear, but terrible at the quarter panels, it's turned down and does not fit even with the quarter extensions, added a couple shims, looks better, does anyone have a better way to make it fit right

 

5/15/2017 10:00 AM  #2


Re: Fitting rear bumper on a 65 coupe

JeffS wrote:

I've got a brand new rear bumper and brackets, fits good along the rear, but terrible at the quarter panels, it's turned down and does not fit even with the quarter extensions, added a couple shims, looks better, does anyone have a better way to make it fit right

I'm working on the same thing.... I'm just making shims to make it the best I can
 

 

5/16/2017 7:36 PM  #3


Re: Fitting rear bumper on a 65 coupe

If you have aftermarket bumper brackets, it will be very difficult to align it. Even with original brackets and an aftermarket bumper, shims are typically required.
The top of the bumper ends should be parallel to the bottom of the end caps. Typically the bumper will not stick out past the end of the end caps. The end cap vertical line should follow down the bumper.

I used washers for shims on mine.


Money you enjoy wasting is NOT wasted money... unless your wife finds out.
 

Board footera


REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.