| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
I recently replaced my turn signal switch when I rewired my 65. The turn signals quit working so I went to investigate and I checked the molex connection and they started working, I didn't even have to unplug it. Is there anything I can use to help make a better connection at the molex connector? A spray or something? On a side note, the low beams quit working as well, I traced it back to a bad dimmer switch that I just replaced, go figure!.
Offline
Check out Caig Laboratories, they market contact cleaner "R5 Power Booster", as well as contact treatments "Deoxit" and Pro Gold", among other similar products.
If you can get to the contacts, try using a pencil's eraser, this works well to take off any tarnishing w/o abrasiveness of scotch-brite or (worse) sandpaper.
Offline
All the contact pins were new, I put some deoxit on them and pushed them together several times, I guess time will tell!
Thanks
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |