FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

9/20/2017 9:41 PM  #1


"How to"- Install 67-68 Mustang LED Tailights

How to add LED Taillights (Non-Sequential) for your 67-68 mustang. This can also be done with other years so long as you get the correct kits from CJ Pony.

Single bulb just doesn't look right. Also, it does not evenly distribute or illuminate your taillights that well:

CJ Pony Parts: 
CJ's Part Number: =TLLED13 (2 needed)

LED panel goes straight to your taillight connector without issue or modification:

Remove taillight housing screws from the rear:

Once screws are removed, you can pull out taillight bezels. Push on the lens inward to break sense loose from the taillight panel.

If in bad shape, now is a great time to replace your lens gasket:


Remove 6 screws holding sense in place to prep for the new lens installation:


One lens is installed and gaskets have been replaced if needed, connect LED connector to taillight socket:

Installation of the housing is processed in reverse order as above. For this kit, you will need to replace your flasher with this special LED flasher specific to these taillights. CJ's Part Number: =12pxHW2811:

Locate original flasher under the dash, remove and replace flasher with the new flasher. It will need to be grounded to work properly:

Test your lights and make sure everything is working properly and you are done:


Completion time: 30min

Great illumination at day and at night. Evenly distributed lighting, and looks great too!



 

Last edited by Ramses (9/20/2017 9:43 PM)

 

Board footera


REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.