FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

3/13/2019 2:05 PM  #1


Misc parts for sale

-original ford hood latch grill support for a 67.  Sure it will probably fit better than a reproduction.  $25 plus shipping

-Braided stainless steel power steering hoses. These were made for me by pirtek with the ends crimped on.  Made to work with a KRC pump and a power rack & pinion.  $75 plus shipping

-Billet Lecarra Steering wheel adapter(9 hole).  $50 plus shipping

-Total control Gbar template/jig for welding Gbar link brackets to 9" rear end.  $40 plus shipping

-14" k&N filter  $20

-1967 factory steering column. No tilt and no steering shaft as it was early unit and shaft built in to box. Make offer

-Un-used set of leaf spring shackles. These raise the rear about 1".

March billet aluminum power steering bracket and pulley for using GM Saginaw pump. New with hardware. Went with a KRC pump so i didn't use it. Make offer.

Small Block Ford Thermostat housing. Good quality item that is new never used. I needed 90 degree to go with serpentine belt set up.



will supply pics if anyone is interested.  Will be adding other parts and some tools.
 

Last edited by 1fststang (3/15/2019 6:55 AM)

 

Board footera


REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.