| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
My 65 Mustang seems to be missing a few pieces. I tried installing the brackets today that hold the column in place but there were no bolts in the top half of the bracket. Does somebody have a photo of what that should look like? Do the bolts screw into the bottom of the dash? Or how does that work?
thank you
Last edited by MWM (4/20/2013 5:48 PM)
Offline
The pedal support has two captive nuts that fit 5/16" coarse threads. There should be a stud about 1-1/4" long that screws into those nuts. Then they go through the dashboard flange, through the cardboard insulator and then through the U-clamp, normally topped off with a pair of self-locking 5/16" hex nuts.
When you put it together, put the studs in the pedal support first. It is near impossible to get the studs threaded in from below because there are just too many pieces to hold together at one time.
The U-clamp has a tang on it that fits into a slot in the steering column so it stays clocked at the correct position. The slot allows some vertical adjustment so you can set the column height so the horn contacts are compressed just the right amount.
Offline
Thank you Steve!
i understand a little better what you were describing on the order of installation. I'll get some hardware and get started.
Thanks!
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |