| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
I installed MS 2.3l brakebooster braket kit, and pedal pin on my 65. What should the 2.3l booster pedal rod length be adjusted to?
Offline
The booster input shaft is not adjustable.
The output shaft should be adjusted to 1.0” from the mc mounting surface. That dimension fits most Ford master cylinders. The final fit check is to have about 0.010” clearance betwen the end of the booster output shaft and the piston in the master cylinder.
Offline
Aweomse thanks Steve and for correcting me.
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |