FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » Swap Meet
  •  » msd 8503 e curve

    • 1 of 1

       

    7/30/2013 8:24 PM  #1

    gremlinsteve
    Active Member

    Offline

    Registered: 7/31/2013
    Posts: 5

    msd 8503 e curve

    this is a brand new mad pro billet electronic distributor.
    it has a internal rpm limiter, and its advance is all electronic.
    the distrubutor can be run as is, no need for a msd box. comes with the cap, rotor and a set of red msd plug wires.

    this was placed into my wifes 289 for about 2 hours of run time. break in only. i have moved over to a different setup and do not need this. 

    i have the install instructions with the listed mad timing curves ext..

    msd part number 8503. its called the e-curve.


    here is what it looks like. it also runs a vacuum advance. the gear is fine. and has no wear.


    i will garauntee it is brand new and in workable condition folks...no silly trick. i do not have time for it.

    it is boxed and ready to go. how about 300 bucks? ill cover shipping. its boxed and ready to go. ill throw in the wires for free....
    located in houston

    steve......

     

    1/03/2014 5:01 PM  #2

    synger123
    Unregistered

    Re: msd 8503 e curve

    I am in the market for an MSD 8503 Distributor and wires. Can you and I make this happen? Which gear comes with it?

    Last edited by synger123 (1/03/2014 5:03 PM)

     

     

    1 of 1

  • Index
  •  » Swap Meet
  •  »  msd 8503 e curve

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.