FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » Toploader Measurement Needed

    • 1 of 1

       

    2/12/2021 12:44 PM  #1

    RPM, aka Bearing Bob
    Senior 24-7 FYI Addict

    Offline

    From: Bakersfield, Ca
    Registered: 9/17/2013
    Posts: 3,249

    Toploader Measurement Needed

    If someone has a toploader handy, I need the OD measurement of the tube portion of the bearing retainer. Thanks.

    Bob. 69 Mach 1, 393W, SMOD Toploader, Armstrong  steering, factory AC.
     

    2/12/2021 1:23 PM  #2

    retired65
    FYI FORD Member

    Offline

    Registered: 6/18/2020
    Posts: 36

    Re: Toploader Measurement Needed

    Mine is 1.435 and off a '67 Mustang with small input shaft.  if you need the extra one I have let me know  Jerry

     

    2/12/2021 1:50 PM  #3

    RPM, aka Bearing Bob
    Senior 24-7 FYI Addict

    Offline

    From: Bakersfield, Ca
    Registered: 9/17/2013
    Posts: 3,249

    Re: Toploader Measurement Needed

    Thanks Jerry, and yes it's the small block shaft.

    Bob. 69 Mach 1, 393W, SMOD Toploader, Armstrong  steering, factory AC.
       •Thread Starter
     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  Toploader Measurement Needed

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.