| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
Brand:Mallory Ignition
Manufacturer's Part Number:4255411
Part Type:Distributors
Product Line:Mallory Comp S/S 42 Series Distributors
Summit Racing Part Number:MAA-4255411
UPC:769105120968
Computer-Controlled Compatible:No
Trigger Style:Magnetic
Advance Type:Vacuum and mechanical
Cap Style:Male/HEI
Mechanical Tach Drive:No
Slip Collar:No
Gear Material:Steel
Ignition Box Required:No
Distributor Gear Rotation:Standard
Distributor Cap Color:Red
Housing Material:Billet aluminum
Housing Finish:Natural
Marine Use:No
Quantity:Sold individually.
Notes:Includes vacuum advance eliminator plate.
Series 42 distributors feature the following:
* CNC-machined billet aluminum housing
* Ball bearing upper and lower bushings for maximum stability at high rpm
* 208 Series distributor cap with spark plug wire retainer
* Ready to run
* Easy-to-adjust mechanical advance
* Vacuum advance with vacuum advance eliminator kit
Bought to use on my new 427 stroker (351w based) but turns out it could not be set up so my Atomic EFI computer could control it. Cap is painted black. Has never been run, has steel gear for roller cam. Wish I could use it because it sure looks better than the MSD dizzy I wound up with.
$189 plus shipping. I paid $259 at Summit for it. Email steve@mustangsteve.com if interested.
Last edited by MustangSteve (10/18/2013 8:31 PM)
Offline
Hey Steve, can I get the measurement from the base that mounts on the intake to the top ring of aluminum that the cap sits on please? I'm limited on the height I can use. Thanks, Bob.
Last edited by rpm (11/10/2013 10:29 PM)
Offline
I'll measure it.
Dont you care how high the cap is as well?
Offline
Absolutely, that will work. Thanks.
Bob
Offline
From the surface that would contact the block to the top of the aluminum part is 5". To block to tip of coil terminal is 8".
Offline
Thanks Steve, but that's too high to fit under my Monte Carlo bar.
Bob
Offline
I use a curved MC bar. fit great with that one!
Offline
Still for sale
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |