| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
Working on my 67 Fastback. I have to make a coupe patches to repair rust in the two bottow corners of the rear window opening.
Originally they brazed the joints in this area. I dont have a torch so looking for advice on best way to seal the bottom corner joints. Should i try an find someone with a torch or borrow one? Would mig welding that joint work as good.
Any advice appreciated,
Offline
You should have no problem mig welding this area. As for sealing, just weld the joint solid, then there'll be nothing to leak.
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |