| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
Hey guys,
I have an 8 inch houseing that a local guy is buying, buttts when I pulled it out from under the shelf, I noticed some (3) of the 10 diff. houseing bolts were a little messed up. I have extras and would like to remove and replace them and was wondering which is the best way you guys go about doing this. Center punch?, or drill them out? or just hit em with a Big hammer?
Thanks!
Offline
I used an air hammer with a center punch type bit in it. Use hearing protection! Drives them right out.
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |