FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » T5 bellhousing question

    • 1 of 1

       

    11/30/2015 4:14 PM  #1

    mustang66
    Active Member

    Offline

    Registered: 11/24/2015
    Posts: 5

    T5 bellhousing question

    I purchased an E6ZR bellhousing, block plate and clutch fork off ebay and ended up being sent an E3ZR instead.  Tried searching but haven't found a definite answer yet.  Will the E3ZR work with the 10.5" clutch?  Some say both bellhousings are the same and others say they are not.  I will keep this one if it will work, but will have to send it back if not.  Thanks

     

    12/01/2015 4:02 PM  #2

    mustang66
    Active Member

    Offline

    Registered: 11/24/2015
    Posts: 5

    Re: T5 bellhousing question

    Unless somebody has some information that is different, I called Modern Driveline and the guy said both bell housings will interchange and the E3ZR bell housing will work with the 10.5" clutch.  Just FYI if anybody was wondering also.

       •Thread Starter
     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  T5 bellhousing question

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.