FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » Booster fitment issue

    • 1 of 1

       

    8/24/2018 3:59 PM  #1

    Cjkcue
    Unregistered

    Booster fitment issue

    So I have the brake booster that mustang Steve offers as well as the PB2 kit (plate on pedal support and relocated pin). I also purchased the 2000 v6 mustang master cylinder because I have 4 wheel disc brakes. When I go to install the master cylinder on the brake booster the reservoir contacts the booster and won’t sit flush and basically can not work. The booster has a depression where the master mounts. Should there be a spacer there or do I have the wrong combination. I tried ordering another booster for the Fox 4cyl but it’s the same. Is there a booster I should be using with a flat face for mounting?

     

    8/24/2018 6:13 PM  #2

    MS
    Forum Originator

    Offline

    From: Canyon Lake, Texas
    Registered: 1/24/2013
    Posts: 12,304

    Re: Booster fitment issue

    There are flat faced boosters for Fox four cylinder cars that will fit. If you got the booster and master cylinder from MS, please contact us by email.
    Info@mustangsteve.com

    Money you enjoy wasting is NOT wasted money... unless your wife finds out.
     

    8/24/2018 6:53 PM  #3

    Cjkcue
    Unregistered

    Re: Booster fitment issue

    Will do. Thank you.

       •Thread Starter
     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  Booster fitment issue

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.