FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » Verifying I don't need this part

    • 1 of 1

       

    3/03/2019 6:59 PM  #1

    Phydeauxman
    FYI FORD Member

    Offline

    Registered: 2/12/2019
    Posts: 24

    Verifying I don't need this part

    I think the part below came as part of my clutch cable kit that I bought from MS. I think it is the part referred to in the instructions where it says "Remove and discard black rubber bushing from top of new cable". It has been so long ago that I started this project (and am now trying to get it finished) that I can't remember where this part came from.

     

    3/04/2019 9:58 AM  #2

    josh-kebob
    Senior 24-7 FYI Addict

    Offline

    From: Madison, AL
    Registered: 4/06/2013
    Posts: 2,902

    Re: Verifying I don't need this part

    You don't need that part. It's removed to allow the cable to seat in the aluminum firewall mounted bracket that came in your kit....

     

    3/04/2019 9:58 AM  #3

    Phydeauxman
    FYI FORD Member

    Offline

    Registered: 2/12/2019
    Posts: 24

    Re: Verifying I don't need this part

    josh-kebob wrote:

    You don't need that part. It's removed to allow the cable to seat in the aluminum firewall mounted bracket that came in your kit....

    Great...thanks for the reply

       •Thread Starter
     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  Verifying I don't need this part

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.