FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » Just rebuilt my KH brake pressure differential/proportioning valve

    • 1 of 1

       

    7/19/2013 4:17 PM  #1

    jerseyjoe
    I FYI 24-7

    Offline

    Registered: 4/01/2013
    Posts: 789

    Just rebuilt my KH brake pressure differential/proportioning valve

     Or combo valve. I found a great supplier for my 70 Mach1  ( Muscle Car Research LLC ) Kits  for the Mustang  67-69 and 70-73 ...new spring, o'rings ,seals etc...$25.Go on line and check it out, nice pictures and directions....jj

    "Never put a question mark where God put a period "  Richard Petty
     

    7/22/2013 6:55 AM  #2

    Ron67
    Active Member

    Offline

    From: Nashville, TN
    Registered: 4/01/2013
    Posts: 9

    Re: Just rebuilt my KH brake pressure differential/proportioning valve

    Thanks jerseyjoe.  Your post came at the perfect time.  I just took apart a couple of '67 differential valves and needed proper o-rings, etc.  I didn't know where to find them until your posted.

     

    7/22/2013 8:44 AM  #3

    jerseyjoe
    I FYI 24-7

    Offline

    Registered: 4/01/2013
    Posts: 789

    Re: Just rebuilt my KH brake pressure differential/proportioning valve

    Ron67 wrote:

    Thanks jerseyjoe.  Your post came at the perfect time.  I just took apart a couple of '67 differential valves and needed proper o-rings, etc.  I didn't know where to find them until your posted.

     
    Ron,apply a little air pressure in the ports to get the valves/pistons out....jj

    "Never put a question mark where God put a period "  Richard Petty
       •Thread Starter
     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  Just rebuilt my KH brake pressure differential/proportioning valve

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.