Trunk redo

Skip to: New Posts  Last Post
Posted by BillyC
10/10/2018 6:50 PM
#1

The original vinyl mat in my 66 coupe finally bought the farm so I'm looking at a low buck redo. Anybody have any ideas/pics on custom trunks?


"anyone that stops learning is old, whether at twenty or eighty"Henry Ford
 
Posted by 6sally6
10/10/2018 9:49 PM
#2

I put in some polystyrene foam board on the sides and bottom....then glued black carpet over that. I built a speaker box for the rear speakers and covered it with carpet also. (Real lo bucks deal) I sealed ALL the holes I could find in the trunk (there were a BUNCH) Spray adhesive works pretty good (and smells GREAT!)
Really dressed up the trunk area and quieted down the road noise and dust migration and fumes.
I would take a picture butt it just looks like a "black hole".
6sally6


Get busy Liv'in or get busy Die'n....Host of the 2020 Bash at the Beach/The only Bash that got cancelled  )8
 
Posted by rpm
10/11/2018 8:06 AM
#3

Ya, I did the custom trunk deal, only because my son wanted to do it. Never again though. It a real pita getting to stuff behind the panels, although they are easy enough to remove.







There is a panel that covers the two speakers.

Last edited by rpm (1/06/2019 1:44 PM)


Bob. 21.5 freeway MPG 69 Mach 1, 5.0 GT40P heads, SMOD Toploader, Armstrong  steering, factory AC
 
Posted by Husky65
10/12/2018 4:40 PM
#4

I neatened up my trunk a couple weeks ago. It was one of those things that was eating away at me for a few years. I am still going to fix up where the hinges come through, and make a little 'box' that goes around it. Only took me a weekend, but was a pain in the but as I have no patience when it comes to woodwork ha ha.
I have an efi tank, plus the fuel filter in the trunk so I wanted whatever I came up with to be easily removable.
10 removable screws hold the entire trunk together(plus some interefence fitting between the panels/body. Can remove the floor and access the efi gear in about 1 minute.

Also cleaned up the battery box and replaced my moroso box with the taylor one. As the taylor one is fully square(unlike the moroso which has indents in it), there is plenty of space inside, which allowed me to fit my starter mega fuse, rear power distribution and isolator all in the box.

 
Posted by Husky65
10/12/2018 4:46 PM
#5

 
Posted by 50vert
10/13/2018 5:10 AM
#6

Hey Husky, great boot!! Good ta see 'nother Ozzie here ,,, Welcome to The best place.
I've always liked your car ... don't be shy with pics.


"Those telephone poles were like a picket fence"
 
Posted by Nos681
1/06/2019 1:46 AM
#7

Look at Rock Auto. They have trunk and interior flooring by ACC with the best prices that I’ve been able to find.  I purchased my interior flooring for my ‘65 coupe.  Extremely satisfied.  Have considered doing my trunk but holding off until important projects like driveline reassembly is complete first!

https://www.rockauto.com/en/catalog/ford,1965,mustang,4.7l+289cid+v8,1333381,interior,trunk+floor+covering,561

 
Posted by 6sally6
1/06/2019 6:39 PM
#8

Yeah!.....Nice look'in boot(y)!!
I just THOUGHT my trunk looked good...after see'in these...WOW!
Funny how the old trunk is usually the last section that gets "dressed-up"!
6s6


Get busy Liv'in or get busy Die'n....Host of the 2020 Bash at the Beach/The only Bash that got cancelled  )8
 


 
Main page
Login
Desktop format