FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » Started wet sanding

    • 1 2  Jump to

       

    4/29/2025 7:28 AM  #26

    RTM
    Senior 24-7 FYI Addict

    Offline

    From: Cape Coral FL
    Registered: 5/22/2019
    Posts: 1,853

    Re: Started wet sanding

    The hood, decklid and rear bumper were Maier products.   The hood and decklid required a ton of bodywork to get flat.  I had a lot of time invested in them to get them to look good.   The rear bumper fit really well and it's a snug fit bumper.  I think the front valance was from Tony.

     

     

    1 2  Jump to

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  Started wet sanding

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.