FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

10/28/2013 1:51 PM  #1


'66 Mustang tail light panel install

Following along with the install page here at Mustangsteves (thanks Steve!).I'm curious if you just leave the metal bare along the backside of the taillight panel where the ~40 spot welds were at the bottom that I drilled out, and also where it mates up to both quarter panels or if it is advisable to spray something such as weld-thru primer first to both mating surfaces?

Thanks,

 

10/28/2013 4:11 PM  #2


Re: '66 Mustang tail light panel install

Weld-thru primer is best, but it lasted this long with no coating from the factory. 

I would use the weld-thru primer, weld it together, clean it, shoot it with primer, and seam seal everything when you get through.  Then apply body color.


Money you enjoy wasting is NOT wasted money... unless your wife finds out.
 

10/28/2013 5:12 PM  #3


Re: '66 Mustang tail light panel install

Ok, will do - thanks, going to do that along with shooting epoxy after I get the filler work complete. The quarter panel sits a little lower then the 1/4 panel extensions - not too happy about it, even though I bought dynacorn quarters.

     •Thread Starter
 

10/28/2013 7:10 PM  #4


Re: '66 Mustang tail light panel install

Did you have any issues lining the 1/4 extensions up with the outer side of quarter?  A tial light panel was installed but the extension sticks out about a 1/4 of inch. If I adjust it on side then it sits up higher on the deck lid side?

 

10/29/2013 3:45 PM  #5


Re: '66 Mustang tail light panel install

Yes, I am having issues with the 1/4 panel extensions lining up right with the new quarters I installed, now worse when I try and "dry-fit" everything together before welding. They may be sticking out 1/8"-1/4" right were the tab is on the taillight panel at the outer top corners. If I hammer those tabs flat it'll fit, but i'm not sure if it will look good once I bolt together the lenses...

     •Thread Starter
 

10/29/2013 3:58 PM  #6


Re: '66 Mustang tail light panel install

Always bolt the light buckets in place before welding.


Money you enjoy wasting is NOT wasted money... unless your wife finds out.
 

Board footera


REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.