| ||
| Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
Following along with the install page here at Mustangsteves (thanks Steve!).I'm curious if you just leave the metal bare along the backside of the taillight panel where the ~40 spot welds were at the bottom that I drilled out, and also where it mates up to both quarter panels or if it is advisable to spray something such as weld-thru primer first to both mating surfaces?
Thanks,
Offline

Weld-thru primer is best, but it lasted this long with no coating from the factory.
I would use the weld-thru primer, weld it together, clean it, shoot it with primer, and seam seal everything when you get through. Then apply body color.
Offline
Ok, will do - thanks, going to do that along with shooting epoxy after I get the filler work complete. The quarter panel sits a little lower then the 1/4 panel extensions - not too happy about it, even though I bought dynacorn quarters.
Offline
Did you have any issues lining the 1/4 extensions up with the outer side of quarter? A tial light panel was installed but the extension sticks out about a 1/4 of inch. If I adjust it on side then it sits up higher on the deck lid side?
Offline
Yes, I am having issues with the 1/4 panel extensions lining up right with the new quarters I installed, now worse when I try and "dry-fit" everything together before welding. They may be sticking out 1/8"-1/4" right were the tab is on the taillight panel at the outer top corners. If I hammer those tabs flat it'll fit, but i'm not sure if it will look good once I bolt together the lenses...
Offline

Always bolt the light buckets in place before welding.
| REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |