FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

11/26/2013 11:25 AM  #1


Interesting brake issue on my 69 coupe

Ever since I bought the 69 T5 coupe, it has had overly sensitive brakes.  The car has factory power disc brakes.  Light pedal pressure would stop the car if a normal stop is required.  But, if you needed to stop quickly, it went into panic mode and locked up the rears.  I was going to get around to fixing it... someday.

Yesterday I went to install the new Edelbrock front shocks, a 30 minute job.  #THE LAW.  During the job, I discovered the PO had installed the front calipers on the wrong side of the car.  I am surprised it had any pedal at all.  So, the job got extended a bit and the calipers were swapped.  Then I discover my brake bleeder bottle I have had for 25 years has a crack in it, plus AFTER I get the calipers on the car, I twisted off one of the bleeder screws.  So, $19.95 later I will have a replacement caliper in hand and hopefully can find a new bottle to replace my old faithful bleeder.  The calipers looked fairly new, so I am only going to replace the one with the problem.  I bet this cures the sensitive brakes and makes the car stop as it should.  The front pads and rotors look brand new, as obviously they have never seen any braking action.


Money you enjoy wasting is NOT wasted money... unless your wife finds out.
 

11/26/2013 2:32 PM  #2


Re: Interesting brake issue on my 69 coupe

I know I have the Granada Brakes on my 69 and it doesn't take much foot pressure and your stopping quickly. 

Steve69

 

11/26/2013 8:55 PM  #3


Re: Interesting brake issue on my 69 coupe

Now that is a funny story... coming from the 'brake guy'.


(Pinto!)
 

11/27/2013 7:20 AM  #4


Re: Interesting brake issue on my 69 coupe

McStang wrote:

Now that is a funny story... coming from the 'brake guy'.

Sounds like yesterday he was the "BREAK" Guy..... 


"The OLDER I Get....The FASTER I Was..."
 

11/27/2013 10:49 AM  #5


Re: Interesting brake issue on my 69 coupe

So Steve whats the rest of the story, did this solve the braking issue?


If this forum can't fix it, it isn't broke.
 

11/27/2013 2:04 PM  #6


Re: Interesting brake issue on my 69 coupe

Haven't had time to bleed the brakes yet...


Money you enjoy wasting is NOT wasted money... unless your wife finds out.
     Thread Starter
 

Board footera


REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.