| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
I can't believe I am asking this but I need help with the sequence of installation of my tail light parts on my 66 Coupe. I have 2 gaskets, one is a white foam gasket and the other a black rubber gasket. Does the white foam gasket go between the housing and the tail light panel or am I mistaken?
Offline
Thin one goes between light body and taillight panel. That one keeps water out of the trunk. The thicker one goes between the lens and the light body. It keeps water out of the light.
Offline
Thanks Steve! Now for question #2. The screws that hold the gas filler tube to the body. Do you know what size they are? I want to use a stainless screw but not sure what the correct size would be.
Offline
I was getting ready to post the same question about the gasgets back there....timely post for me too...Thanks
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |