| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
1 of 1
Offline
Can anybody check these wiring harness connections in this pic. The wire colors don't match the wiring diagrams from Ford. This is on a 65 with a manual transmission and rear back-up lights.
Thanks
Offline
What seams to be the question as if they are for the NSS then they are from the starter circuit. I would think I taped into them for my alarm kill and it works fine, same wires.
Offline
The info on the picture provided agrees with the wiring diagram manuals I have for both the 65 & 66 Mustangs. The back-up light circuit is wire #140, black-red. The courtesy lights are wire #32, red-black.
I will add that the 65 wiring diagram does not include a page for the "Ignition, Starting and Charging" diagram as the 66 manual does. This diagram in the 66 manual shows the "32" wire single connectors that you have pointed to.
Send me a PM with your email address and I'll forward some info.
Offline
Are you trying to figure out where the harness connects to the car wiring? There is a bullet plug up high under the dash where two wires plug into each other on manual trans cars. You unplug those and the NS wire plugs into each loose end.
Offline
I was trying to find out where the wires go with the arrows because the wire colors don't match
1 of 1
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |