FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » Looking for 1 piece of 67-68 fastback wraparound trim

    • 1 of 1

       

    3/25/2023 7:09 PM  #1

    HAVEaSigAR
    FYI Addict

    Offline

    Registered: 1/24/2015
    Posts: 193

    Looking for 1 piece of 67-68 fastback wraparound trim

    I need 1 of the small corner pieces, does anyone have one laying around to sell me? Or can point me on the right direction? I've seen some on ebay but $150 is a bit much

     

    3/25/2023 7:10 PM  #2

    HAVEaSigAR
    FYI Addict

    Offline

    Registered: 1/24/2015
    Posts: 193

    Re: Looking for 1 piece of 67-68 fastback wraparound trim

    image uploader

       •Thread Starter
     

    3/26/2023 5:41 AM  #3

    TKOPerformance
    Hyper FYIFORD ADDICT

    Offline

    From: Newark, DE
    Registered: 12/15/2014
    Posts: 7,471

    Re: Looking for 1 piece of 67-68 fastback wraparound trim

    Its reproduced, but it seems only available as a full set.  Fit is decent though (I think its made by Dynacorn).  I replaced the entire rear trim in mine close to 10 years ago as the original stuff was in super rough shape.

    https://www.cjponyparts.com/rear-molding-set-mustang-fastback-1967-1968/p/QTP9/

     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  Looking for 1 piece of 67-68 fastback wraparound trim

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.