FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

10/09/2023 1:18 PM  #1


Wanted Fox Body *Core* Alternator and A/C Compressor

Hey guys, I am doing some mock up with Fox body bracketry and looking for a 89-93 Fox body alternator and compressor. These are just for mock up so non-working cores are preferred. 

 

10/09/2023 10:43 PM  #2


Re: Wanted Fox Body *Core* Alternator and A/C Compressor

Not sure if you know Raymond, but a 3G alt can fit, and is a way better alt than a 2G firestarter.


"Those telephone poles were like a picket fence"
 

10/10/2023 8:33 AM  #3


Re: Wanted Fox Body *Core* Alternator and A/C Compressor

50vert wrote:

Not sure if you know Raymond, but a 3G alt can fit, and is a way better alt than a 2G firestarter.

Thank you! Good point and yes once my mock up is finished I was hoping to use a 3G. I've not held the two side by side, is there much of a difference in sizing?

What I am doing is swapping my Lightning over to a Fox body accessory setup to help make room for twin turbos. I have the brackets, but wanted to throw a core alt and core A/C compressor on there to check pulley alignment and check room for the various turbo piping.

 

     Thread Starter
 

10/11/2023 10:24 AM  #4


Re: Wanted Fox Body *Core* Alternator and A/C Compressor

Enough of a difference that a 3G requires grinding on the alt bracket. It sounds like you'll need all the room you can get. A 6G from a 2001-2004 V6 mustang, should fit with no grinding, and is smaller than a 3G.
Should be cheapish at a pick-n-pull.
 

Last edited by 50vert (10/11/2023 10:28 AM)


"Those telephone poles were like a picket fence"
 

10/11/2023 10:25 AM  #5


Re: Wanted Fox Body *Core* Alternator and A/C Compressor

50vert wrote:

Enough of a difference that a 3G requires grinding on the alt bracket. It sounds like you'll need all the room you can get. A 6G from a 2001-2004 V6 mustang, should fit with no grinding.
Should be cheapish at a pick-n-pull.
 

Awesome information, thank you I will go look for one!
 

     Thread Starter
 

11/29/2023 7:21 PM  #6


Re: Wanted Fox Body *Core* Alternator and A/C Compressor

I have an alternator you can have for shipping cost, if still needed.


Money you enjoy wasting is NOT wasted money... unless your wife finds out.
 

11/29/2023 7:24 PM  #7


Re: Wanted Fox Body *Core* Alternator and A/C Compressor

MS wrote:

I have an alternator you can have for shipping cost, if still needed.

Yes sir I am! I will PM you my address.
 

     Thread Starter
 

Board footera


REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.