FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?



  • Index
  •  » Swap Meet
  •  » 8" Rear End (67-70 Mustang)

    • 1 of 1

       

    1/18/2025 10:27 AM  #1

    John Ha
    I FYI 24-7

    Offline

    From: Mitchell, SD
    Registered: 4/02/2013
    Posts: 944

    8" Rear End (67-70 Mustang)

    I'm selling a Ford 8" differential with center chunk.  The differential is 54-3/4" wide, measured from the outside of the end flanges.  This is the factory width in the 1967-1970 Mustangs.  The unit is complete (but no axles) and, as far as I can tell, straight.

    The center section tag says that it's a 2.79:1 ratio with a Powertrax Lock-right installed.  It worked well but developed a lot of slop, so I removed it.  I didn't see anything broken inside but it will need to be gone through.  The casting number on the center section is C7OW-4025-A and has the FOMOCO logo in the casting as well.

    Asking $200/offer, cash only.  I don't want to ship this but am willing to travel a little - say an hour from my home in Mitchell, SD - to meet you.

    Please PM me with interest/questions/offers






    Last edited by John Ha (3/13/2025 9:12 AM)

    Founding Member of the Perpetually Bewildered Society
     

    3/13/2025 9:13 AM  #2

    John Ha
    I FYI 24-7

    Offline

    From: Mitchell, SD
    Registered: 4/02/2013
    Posts: 944

    Re: 8" Rear End (67-70 Mustang)

    Here's a photo of the casting number and tag on the third member.  Unfortunately I was not able to add it to the original ad post.

    Founding Member of the Perpetually Bewildered Society
       •Thread Starter
     

     

    1 of 1

  • Index
  •  » Swap Meet
  •  »  8" Rear End (67-70 Mustang)

    • Board footera

     

    Powered by Boardhost. Create a Free Forum


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.