| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
Took a little over 6 hours....partly because I had added some extra welds that took extra time to remove...but it came out pretty good. And it was a Ford tooling piece I got from Mustangs Unlimmited that does have a slight bow. Have since ground the spotwelds flush. Still waiting on the weather to warm up and stay dry for a few days so I can prime this beast and start assembling!
Offline
Looking good
still have to do this job aswell
did you make a brace before cutting it out,or is this not required ?
Tonie
Offline
Looks like good progress! You must have warmer weather than MI right now to be able to think about paint.
Best of luck,
Offline
Tonie wrote:
Looking good
still have to do this job aswell
did you make a brace before cutting it out,or is this not required ?
Tonie
I don't know if it was required, but no, I didn't make a brace, just measured and recentered the new piece. The corners were pretty rigid.
Offline
Looks good . Don't forget to test fit that lower valance
Offline
I did test fit the valence, but going to buy a new one as the original has a few dents, dings and bends that I don't want to mess with.
Offline
mainiac1 wrote:
I did test fit the valence, but going to buy a new one as the original has a few dents, dings and bends that I don't want to mess with.
That tag line of yours says alot!!!
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |