| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
1965 ford mustang coupe original 6 cyl car changed to V8 302 auto.....the following is etheir new or rebuilt! complete rebuilt 302 4bbl motor with all the plug wires/plugs/dist/etc done with a little rv cam and less than 100 miles, complete rebuilt c-4 auto trans, sterring inner and outters,upper and lower control arms,idler arm,sway bar bushings,struts bushings,shocks front/rear,granada disc brake change over with brake hose's,front disc pads,rear end axle bearings,rear end third member ? dont remember but most likely,rear drums,rear brake shoes,rear brake wheel cylinders,U-joints,fuel tank,fuel tank sender,alt,feul pump,water pump,radiator,all hoses,belt,complete dual exhaust system,trans mount,both motor mounts,carpet,custom front seats,custom auto shifter,h-liner. the engain bay and undercarrage was completely cleaned and painted, i'm sure other stuff was done that i am probably forgetting.....dont remember if i have the title or not but i will get it if i can't find it, i drove this car home from 15 miles away and it was tight,beefy sounding and ran very strong!! that was a few years ago and its been sitting in storage ever since with a few start ups and that is it, i was going to finish the minor body work and paint it but that never happend! the older gentelmen i got it from built it for his son but mom said no with the mountain roads here after getting a ride in it, he worked at a auto repair and front end shop in grassvalley ca and they did all the work.it has differant wheels/tires now that will need replaced. its not real pretty but its pretty darn straight with no rust.....will post pictures soon. asking 7500.
Last edited by jgstang (4/01/2014 9:57 PM)
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |