| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
1 of 1
Offline
On my late '65 mustang fastback, I have the panels bare. One panel have the triangle cut outs which is '66 for the chrome dish. However my angled panel does not have the nuts to bolt in the shoe shaped rubber bumper. May I get a measurement so I can drill the hole to add the shoe shaped rubber bumper? I hope this is not too confusing!
Thank you!
Offline
Do you have some pictures of the area you are talking about?
Offline
You want to use 65 bumpers or 66.??
Mine is early 65 so I can sent measurements for that.
Corky
Offline
Good Evening,
I am going to finish it as a '66 since I have the panels. I don't have a photo, but below is a link showing the bumpers.
Thank you!
1 of 1
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |