| ||
| Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline

My 010 F150 has been sitting for a month for over a month. I took it for a short errand yesterday and an overpowering "something burning odor" was very evident in the cab.
When I checked to rotor temps the front left was 180F and the others were in the 135 range
I'm guessing that the rotors were rusty and the crud just has to be scrubbed off from a bit of driving.
What do you guys think?
Offline
Brakes don't usually give off that much odor. Maybe something on your engine?
Offline
Maybe the front left caliper sticking from sitting to long?
Offline

Buy a fire extinguisher and keep it in your pickup.
Offline

Wheel bearing grease? If the rotor got hot enough, it could cause the grease to heat up also. Although I would think it would have to get very hot for that to happen.
Offline

Drive it 50 miles in stop/go traffic and then reevaluate. I assume you are using an infrared thermometer? I would think any light surface rust would be gone in ten miles, but not sure how much braking you had to do. A stuck caliper is certainly a possibility. I had one on my Ram truck recently, but temperature was up around 500 degrees with others less than 200. It was pretty obvious where the problem was!
Offline

The F series calipers are bad about sticking if they sit for long periods my neighbor had the same problem with a 98 F 100 and my 94 F 350 did the same, the F100 calipers are reasonably priced the F350 not quite so reasonable.
Offline

It seems that the problem was the rust on the rotors, after a few stops all is well in Welland.
| REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |