FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » first start

    • 1 of 1

       

    9/01/2014 6:20 PM  #1

    Steve-G
    I FYI 24-7

    Offline

    From: Glen Rose,TX
    Registered: 4/01/2013
    Posts: 544

    first start

    Fired up the 67 for the first time today with the 5.0 and T5.started right up, set timeing and carb and brought up to temp. Cluch felt good new power brakes felt good , but only pulled it back and forth in the drive way. No break in due to being a used motor. Tryed to finish up the install of the Vintage A/C but ran into problems with the duct work. Instruction said use  2" for defrost and center vents 2.5" for outer vents but the outlets on the pletum of the A/C were to big for the 2" duct.
     

     

    9/01/2014 6:26 PM  #2

    MS
    Forum Originator

    Offline

    From: Canyon Lake, Texas
    Registered: 1/24/2013
    Posts: 12,667

    Re: first start

    My vintage air used 2" for defrost and the four dash registers were 2-1/2", but that was on a 66.
    The hose that comes with the kit looks way too short, but if you cut it to length per the directions, extended as far as it can go before cutting, it will fit perfectly.  Read instructions very carefully !

    Money you enjoy wasting is NOT wasted money... unless your wife finds out.
     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  first start

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.