FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » Swap Meet
  •  » Looking for a 3.70 9" center section.

    • 1 of 1

       

    6/26/2013 10:24 AM  #1

    Greg B
    Senior 24-7 FYI Addict

    Offline

    Registered: 4/01/2013
    Posts: 1,681

    Looking for a 3.70 9" center section.

    to buy or do some trading.  

    I have a 2.50 (if anyone wants to go land speed racing)

    I have a 3.25 been sitting on my shelf, will most likely need rebuilding.

    I have a 2.80 in a Lincoln Versaille full rear axle. (have entire axle with brakes)

    In St Louis Area

    If multiple things can go wrong, the one that will go wrong will be the one that causes the most damage.
     

    6/26/2013 4:54 PM  #2

    MS
    Forum Originator

    Offline

    From: Canyon Lake, Texas
    Registered: 1/24/2013
    Posts: 12,190

    Re: Looking for a 3.70 9" center section.

    Greg, the 65-66 F-100 with 6 cylinder engine typically came with a 9", 3.70 gear 28 spline rear end.  I actually paid a guy to haul one off...

    I would think if you have any salvage yards that deal with old stuff, that would be a good place to look for one.

    Money you enjoy wasting is NOT wasted money... unless your wife finds out.
     

    7/02/2013 5:04 PM  #3

    Alan
    I FYI 24-7

    Offline

    From: Axtell KS
    Registered: 4/03/2013
    Posts: 515

    Re: Looking for a 3.70 9" center section.

    Greg
    pm sent

    Alan
     

    67 Coupe, 5.0 EEC IV Fuel injected. T5, 3:70 rear
     

     

    1 of 1

  • Index
  •  » Swap Meet
  •  »  Looking for a 3.70 9" center section.

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.