Sorry I guess I really asked a bad question. My 65 FB was involved in a passenger collision at some point. It is currently on a frame machine and were having trouble finding the measurements to assure the shouck towers and radiator support are correct. Any help would be greatly appriciated.

Firewall looks good.

I hope these dimensions make sense.  The shocks are not installed so I measured to the inside edge of the slots that face the center of the car.

The first dimension is from the center of a centered hole on the firewall/flange (factory stamped) to the inside of the shock tower slotted hole(s).  The passenger side measured 22" and the driver side measured 22-1/8".  




Next, I measured from the center of this firewall hole forward to the radiator support.  It measured 39-1/4" to the back edge of the support and about 40-3/16" to the front face of the radiator support.

The dimension from the edge of the shock tower slots to the back edge/flange of the radiator support at the center is 27-3/4" on each side.





To clarify the shock tower position, this is the slotted hole I was using.



And this is the position on the firewall.

We were rolling the car around in case some of the pictures look a little odd.  The car was never hit in the front and all braces/bars fit up when installed.  Let me know if you need any other dimensions.

Forgot an important one. From inside slot to inside slot between the shock towers I got 30-1/4".  I also measured from the inside of the flanges rather than the slots and got 31-1/2".
 

Last edited by GPatrick (9/09/2016 4:50 PM)