FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » Shelby traction bars

    • 1 of 1

       

    7/23/2013 12:32 PM  #1

    Brents65
    I FYI 24-7

    Offline

    From: Upstate NY
    Registered: 7/22/2013
    Posts: 542

    Shelby traction bars

    Does anyone have a picture of these on their car? I see on the original MS site the blue print but would like to see how the attach.  

    65 mustang coupe, 351W, AOD 3000 stall, B&M blower, 9inch- trac-loc 3.70 gears, 4wheel power disc brakes.
     

    7/23/2013 2:46 PM  #2

    MS
    Forum Originator

    Offline

    From: Canyon Lake, Texas
    Registered: 1/24/2013
    Posts: 12,786

    Re: Shelby traction bars

    I have a set you could have for cheap if you want them...

    Here is the front attachment where they weld to the torque box.  Pardon the crappy welds that were done 20 years ago, laying on my back, with a gasless MIG, and not bothering to clean off old paint and undercoating.  MIG welds need to be spotless clean to make a good weld.  These did hold up for 20 years with 400HP though.  Now they have been cut off and removed in order to install subframe connectors.

    Money you enjoy wasting is NOT wasted money... unless your wife finds out.
     

    7/24/2013 12:10 PM  #3

    BillyC
    I FYI 24-7

    Offline

    From: Chesapeake, Va.
    Registered: 4/02/2013
    Posts: 967

    Re: Shelby traction bars

    Steve,
    If Brent isn't interested in those I might be.

    "anyone that stops learning is old, whether at twenty or eighty"Henry Ford
     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  Shelby traction bars

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.