FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » Shifter Boot Conversion Plate

    • 1 of 1

       

    8/17/2013 5:52 PM  #1

    KeithP
    I FYI 24-7

    Offline

    From: Scottsdale, AZ
    Registered: 6/10/2013
    Posts: 379

    Shifter Boot Conversion Plate

    Installed a Hurst shifer and didn't want to use sheet metal screws to attach the new boot and trim. So I made this conversion plate. This plate converts the stock holes to the new boot/trim holes. New holes are 6-32.

    Last edited by KeithP (8/17/2013 5:53 PM)

    1966, vert, 347 stroker, T5z, 4 wheel disc, pb, 3.70 LS 9", EPAS
     

    8/17/2013 6:00 PM  #2

    MS
    Forum Originator

    Offline

    From: Canyon Lake, Texas
    Registered: 1/24/2013
    Posts: 12,661

    Re: Shifter Boot Conversion Plate

    Innovative idea.  Want ot make another one?  My 69 needs one.

    Money you enjoy wasting is NOT wasted money... unless your wife finds out.
     

    8/17/2013 7:06 PM  #3

    KeithP
    I FYI 24-7

    Offline

    From: Scottsdale, AZ
    Registered: 6/10/2013
    Posts: 379

    Re: Shifter Boot Conversion Plate

    MustangSteve wrote:

    Innovative idea.  Want ot make another one?  My 69 needs one.

    I had some scrap metal laying around and too much time. The back side has 1/8" sheet rubber glued on to give the 6-32 screws space to go between the plate and tunnel and to provide a seal. No more scrap metal.

    1966, vert, 347 stroker, T5z, 4 wheel disc, pb, 3.70 LS 9", EPAS
       •Thread Starter
     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  Shifter Boot Conversion Plate

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.