| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
Decided to replace my inner splash sields and rubbers , Ordered them from NPD. They came as 4 metal pecies and a bag of rubber parts with a bag of staples.no pre drilled holes .I can not explane how hard it was to hand drill and install all those staples . then I looked on line and they sell the splash shields with the rubber installed for about the same price.
Offline
Been there done it. And I think the ones that are made were only $40 a pair.
Offline
I used pop rivets w/washers instead of those staples - worked fine
Offline
JamesW wrote:
I used pop rivets w/washers instead of those staples - worked fine
+1 Thats what I did too
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |