| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
1 of 1
Offline
AND WHERE DID YOU GET THEM IM LEANING TOWARDS THE 4 AND A HALF REVERSE EYE SPRING FROM MUSTANG PLUS THAT MUSTANGSTEVE SUGGESTED TO ME, THEY ARE FOR MY 66 COUPE.
Offline
Mustangs plus, 5 leaf, mid-eye...25+ years now.
I used their entire suspension kit (springs, sway bars, KYB shocks).
This year I finally removed the 3/4” rear sway bar...too much oversteer and washboard roads were scary if going too fast.
Did not cut coil springs in front.
Car sits level front to rear (fender lip to ground).
KYB’s definitely stiff on washboard roads...and multiple potholes roads.
Steve’s car sits lower than mine.
Hope this helps BILLY 😁
Offline
Mustangs Plus 4leaf standard eye with 1" lowering blocks. I like the ride but wish I would have gone with reverse eye to eliminate the blocks.
Offline
Flex-a-form fiberglass rear monoleafs, just to be different
Tubo
Offline
Mustangs Plus 4 leaf w/reverse eyes for around 20 years.. But I have traction Masters too which negate the need for the extra half leaf.
Offline
The have the 4 and a 1/2 leaf from Mustang plus with standard eye. The ride is nice with the Monroe shocks. They almost stopped the wheel hop from the 390!!
Offline
MUSTANGPLUS IS WINING
Offline
Standard springs in the rear from the Tubo stash! With the Shelby drop in the front I think the little bit of "California rake" looks pretty sweet! Rides good too!
6sal6
Last edited by 6sally6 (10/26/2019 9:14 PM)
Offline
I have the Grab-A-Trak 4 leaf mid eye springs from Mustangs Plus on my 66. It sat too high in the rear so I put 1" lowering blocks on . The stance looks just like Sal's. The Shelby drop in the front with 1/2 coil cut off.
The best mod I did was the 1" front sway bar, also from Mustangs Plus. Doesn't affect the stance but the handling is much improved...
Last edited by zakdaddy99 (10/27/2019 7:49 AM)
Offline
6sally6
Are you using stock coil springs on the front.
Did you cut any coils to get that rake.
Thanks,
Cman66
Offline
They are "second-hand" stock (66) coils with a full coil cut out...I think. Shelby drop and 1" rubber isolation pad . Got that "rake" strictly by accident!!!!!
IF I had it to do over I would use 6 cylinder front coils and a nice shock to start with.
6sal6
Last edited by 6sally6 (10/27/2019 7:41 PM)
Offline
Thanks 6Sally6
Cman66
Offline
Stock front springs with 1/2 coil removed, no Arning drop, stock rear springs with 1" longer rear shackles.
Last edited by Rudi (10/28/2019 9:02 AM)
Offline
Perfecto Rudi nice Vert
Cman66
Offline
Mustangs plus 4 1/2 reverse eye, no wait thats a before
Last edited by bearcat (10/28/2019 10:35 AM)
Offline
I just installed mine 5 leaf mid eye springs.. Lowered my rear by an inch. but still left a bit of forward leaning stance which looks nice.. Almost level but just barely not ..
I got them from Ecklers. Am about to install the bilsteins to go with to make the ride smooth!
1 of 1
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |