FYI FORD - MustangSteve's Ford Mustang Forum
The Internet's Most Knowledgeable Classic Mustang Information
IF YOU HAVE A QUESTION ABOUT CLASSIC FORD MUSTANGS, YOU HAVE COME TO THE RIGHT PLACE!
MustangSteve has over 30 years of Mustang experience, having owned 30 of them and restored several others. With the help of other Mustangers, this site is dedicated to helping anyone wanting to restore or modify their Mustang.... THERE ARE NO DUMB QUESTIONS!!!!!
Visit MustangSteve's web site to view some of my work and find details for:
FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events

You are not logged in. Would you like to login or register?

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  » 1968 fastback

    • 1 of 1

       

    10/31/2019 4:06 PM  #1

    dave p
    FYI FORD Member

    Offline

    Registered: 6/27/2018
    Posts: 15

    1968 fastback

    I would like to know if anybody replaced deck lid molding  the little plastic clips that hold the molding on has a plastic pin that goes down though it to expand the ears to hold it on  when you try to put it it on by pushing molding down it expand the ears and wont go in  any ideas

     

    10/31/2019 9:03 PM  #2

    MS
    Forum Originator

    Offline

    From: Canyon Lake, Texas
    Registered: 1/24/2013
    Posts: 12,291

    Re: 1968 fastback

    Can you post a picture of the clips on the decklid?

    Money you enjoy wasting is NOT wasted money... unless your wife finds out.
     

    11/01/2019 5:27 AM  #3

    TKOPerformance
    Hyper FYIFORD ADDICT

    Offline

    From: Newark, DE
    Registered: 12/15/2014
    Posts: 7,520

    Re: 1968 fastback

    Its been a really long time, but as I recalll all the plastic clips must be on the decklid first.  Then you gently whack the trim down onto the clips.

     

     

    1 of 1

  • Index
  •  » FYI Ford, Classic Mustang Tech Discussion
  •  »  1968 fastback

    • Board footera


    REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.