| ||
| Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
1 of 1
Offline
Good Morning!
Does anyone have a photo(s) showing the location to place all the metal brackets for the rear plastic panels on a '65 fastback?
Thank you!
Offline
are you talking about the interior of the car that holds all the molding?
Offline
Yes! The clips for the plastic pieces.
Thanks
Offline
I will take some pictures of mine. I still have a blank interior, but I did put these back on.
I would like to see those pictures also. Can you post them here or add my email to your list that you send them to. Thanks
Offline
Sorry long weekend was calling. Let me know if these are the clips you are looking for and I will post the rest.
Offline
Thanks Mochaman!
Yes the silver clips in your photo is what I need details of foru fastback. I did a mock up over the weekend but need to make sure.
Thank you!
Offline

Offline

Offline

Offline

Offline
Trying to get the last one to load. I certainy hope these help.
Offline
Sure could have used those pics when putting mine back together. Took them off and 13 years later wondered where they all went exactly. When we took them off we bagged and tagged but 13 years later I couldn't figure out what we wrote down. In my defense, some of the tags were written by my kids that were 10-12 years old at the time. I think we got them back in the right place.
Offline
Thank you Mochaman!
Great photos and very helpful! What year and factory is your fastback? Also, in photos number 2 and 4, there is a rubber bumper above the opening for the trap door, what is that? I thought the plastic panel under the rear window was flush?
thank you again!
Offline
This is a early 1965. I believe a California factory. I don't remember anything more specific.
I am not sure of the bumpers. There were some in there when I took the car apart. It looked like the same Trunk bumper size so that is what I used. They may come back out when I start assembling interior.
Offline
Good Morning,
My fastback is a San Jose GT. I have attached a photo below showing an extra clip at the door opening for the quarter panel. Depending on when and where the car was manufactured, it may not have this. Thank you again!
1 of 1
| REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |