| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Online!
Leaving Bakersfield for the Bash enroute to Bullet Bob's in Montrose.
Offline
Safe travels Bob.
Offline
Are you there yet?
Offline
RPM is down in Utah with front wheel bearing issues. AAA is on the way to his rescue and will tow to Bullets place. No matter the Bash is still the destination.
Offline
Bash Thrash in the middle of the drive sucks.
Online!
Made it to Bullet Bob's about midnight. Thrash will happen when I return.
Offline
Haven’t we discussed that bent spindle axle destroying bearings previously?
Online!
Yes we have Steve, but this time it was the divers side, the opposite from last time. I suppose both spindles could be bent, but the odds of that seems pretty high to me. I will put them between centers to check straightness on the lathe when I get home.
This Motors Manual image is how I adjust the front wheel bearings.
Offline
Is that inch pounds or foot pounds?
Offline
Rpm has bad luck! First, his own car breaks down, so he rides with Bullet to the bash. Then at the bash, Bullet’s F150 poops out, and has to go the Ford dealer for throttle problem.
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |