| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
65 mustang wiper arm drags on windshield with new blades installed
(by drag I mean moves slowly)
Offline
What have you checked so far?
Offline
Nothing so far.
Offline
I would check at fuse (both sides) and at wiper motor to see if you are getting full voltage. You may need to clean up contact surfaces. Check your switch as well.
You didn’t mention if you’re doing this with engine on or off. Is there a difference?
Check battery voltage from positive to ground at/near firewall to make sure you have a good ground as well.
Main feed to fuse box is at start solenoid. May want to check/ clean terminals and lugs too.
Offline
With water on windshield, or dry? Does it change speed when wet?
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |