| ||
Visit MustangSteve's web site to view some of my work and find details for: FYIFORD Contributors' PICTURES - Power Brake Retrofit Kits for 65-66 Stangs - Classic Mustang FAQ's by MustangSteve - How to wire in a Duraspark Ignition - Mustang Ride Height Pictures and Descriptions - Steel Bushings to fit Granada Spindles to Mustang Tie Rods - Visit my EBAY store MustangSteve Performance - How to Install Granada Disc Brakes MustangSteve's Disc Brake Swap Page - FYIFORD Acronyms for guide to all the acronyms used on this page - FYIFORD Important information and upcoming events |
Offline
I might have to try it.
Offline
I am impressed. That's a pretty savey guy. I would never have though of using a computer and HEGO sensors to add air and optimize AFR on a pot. I hope he makes a $billion.
BB1
Offline
Bullet Bob wrote:
I am impressed. That's a pretty savey guy. I would never have though of using a computer and HEGO sensors to add air and optimize AFR on a pot. I hope he makes a $billion.
BB1
I'm guessing you missed it when Gaba mentioned him.
Offline
Guess I did.
Offline
GABA beat me out posting about it 7 hours earlier than I did.
Offline
Bullet Bob wrote:
I am impressed. That's a pretty savey guy. I would never have though of using a computer and HEGO sensors to add air and optimize AFR on a pot. I hope he makes a $billion.
BB1
Question is can this drive the death valley challenge and park up at BB's driveway?
Offline
Only if you adjust carburetor slightly rich and then activate it.
Once up to BB’s house turn it off, make all adjustments for high altitude and turn it back on.
That’s how I would do it.
BB2…are your jets behind the seat?
Offline
Nos681 wrote:
Only if you adjust carburetor slightly rich and then activate it.
Once up to BB’s house turn it off, make all adjustments for high altitude and turn it back on.
That’s how I would do it.
BB2…are your jets behind the seat?
Trunk. I keep them in the trunk now next to the floor jacque.
REMEMBER!!! When posting a question about your Mustang or other Ford on this forum, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on. |