Day
Glad to hear you are doing better.
as Sally said welcome to the zipper club.
Had two episodes of Afib post Heart surgery in Sept 2019.
Doc had given me the heads up that this might happen.
went to hospital got the paddle treatment all is ok.
You are in my thoughts and prayers.
Cman
 

1/18/66 
Cman

I'll get some pictures with measurements tomorrow, and send them on. 

cman

Sall66
Be safe not a good day for man nor beast in your neck of the woods

Cman

Me and new wall art Sexy
SWIMBO and I went to breakfast this morning.
Lady that runs the restaurant saw my shirt and told me to check out
new wall art in gents room.  Here it is fellers.

Cman66

Mike,
Same repair on my left side door .
Careful welding with MIG turned down, decent spacing for penetration, go slow and presto.
Like new door. I used dimples from a bad door. I think the dimples are available to repair this area.

Cman


url=https://ibb.co/g4V1N54][/url]

Test  Worked for me
Cman 

I joined in early 2018 IIRC . Found the site while surfing on Images picture of MS in front of his car.
Lurked for about 2 months then joined. Said it before best site for Mustangers on the planet.
 

Bodyshells weigh  less than 750 lbs bare.
1/8" wall thickness is plenty strong.
I made the spider and door opening braces for my vert from 1/16"
wall 3/4" square steel tubing.
no movement when installed on Rotisserie.
For full body carts VMF site has a few threads with great Pics.
Cman

Thought I would get y'all up to speed on Ol' Paint.
I finished the repairs to the right side wheel house al the welded seams are finished to brushable seam sealer. The lower rear patch behind wheel is fitted and welded about halfway. Replaced the outer door skin on left side from the lower body line down. This allowed me to remove the rust and prime inside of lower door. Lengthened the drain holes and finished door bottom with Rustoleum industrial undercoating. Right side door is toast . If anybody on the forum has a line on a right side door please pass on to me.

Cman
PS 
All of this happened without pictures. LOL
 

T74Y
After I clean any metal by blasting or sanding or whatever method.
Treat with Kleen Strip Prep and etch mixed to a 25% solution and spray on using a garden sprayer it will dry to a powdery look but will protect surface from oxidizing further.

Cman

I've been watching this channel  The craig909 ,
He is using AMD sheet metal to rebuild his  64 Galaxie , looks like great fit and quality
Cman